When you use this in the below image of the folding scheme : TrimHead, TrimFoot, TrimFace = 5 mm (14.173) Some values are determined by the bindery signature : Parameter of the folding scheme (BinderySignature F8-7): We can illustrate this using an example of an 8-page innerwork WorkĢ. Rotate90 (= 90° rotated clockwise in relation to the foldingįlip180 (= flipped (over the foot of the page) in relationįlip270 (= flipped & 3/4 turned in relation to the folding Rotate0 (= not changed in relation to the folding scheme)
When putting folding schemes on a print sheet, information shouldīe given to the imposition software about how there should be flipped Kind of folding) the orientation for the JDF of the print sheet is Properties in the folding process to 'Either direction'.ĭepending on the properties of the folding scheme (grippers and Wish to apply the parameters from the folding scheme, set the Gripper In the job, the properties of the folding scheme are applied. The sheets are delivered "unfolded" to a subcontractor), the propertiesįrom the chosen folding process are applied. This data can be entered in the folding processes of the folding schemeĪs well. Is the front down or up when the folding starts The link between folding scheme and FoldCatalog is defined in the properties In addition, the orientation of a FoldCatalog doesn't correspond to On how the sheet must be folded, the a FoldCatalog must be created per Since the loses are on an other position, depending Notice that a 16-page folding scheme relates to different FoldCatalogs In JDF a folding scheme is more or less a 'FoldCatalog': a fold catalogĭetermines how a print sheet should to be folded. This defines the orientation of the folding scheme in the imposition. The orientation of the lower left pose, and the other poses are calculated This orientation can be set in the wizard 'Change loss scheme': define Of the ‘Orientation’, the folding scheme is being rotated or flipped aroundĬlockwise rotation, and then, in case of 'Flip' the folding scheme The terminology ‘Orientation’ is taken over from JDF. To the prepress, it is important that the input in Cerm should be correct. This information can be exchanged between Cerm MIS and other suppliers e.g. Imposition is sent, by means of a JDF Job Definition Format. The margins that are added to a folding scheme, are positioned in a different Reality, there are 8 different possibilities to position a folding scheme Īs a consequence the position of the pages of the folding scheme, and
Scheme has to be rotated within the imposition: The Cerm software allows to indicate whether a folding